| Part Tightened | N*m | kgf*cm | ft.*lbf | |||
|---|---|---|---|---|---|---|
| Valve rocker arm lost motion damper sub-assembly X Camshaft housing sub-assembly | 10 | 102 | 7 | |||
| Camshaft housing sub-assembly x Cylinder head sub-assembly | 27 | 275 | 20 | |||
| Camshaft timing exhaust gear assembly x No. 2 camshaft | 54 | 551 | 40 | |||
| Camshaft timing gear assembly x Camshaft | 54 | 551 | 40 | |||
| Part Tightened | N*m | kgf*cm | ft.*lbf | |||
|---|---|---|---|---|---|---|
| Cylinder head sub-assembly x Cylinder block sub-assembly | 1st | 49 | 500 | 36 | ||
| 2nd | Turn 90° | |||||
| 3rd | Turn 45° | |||||
| No. 1 water by-pass pipe x Cylinder head sub-assembly | 21 | 214 | 15 | |||
| Part Tightened | N*m | kgf*cm | ft.*lbf | |||
|---|---|---|---|---|---|---|
| Crankshaft pulley x Crankshaft | 190 | 1937 | 140 | |||
| Part Tightened | N*m | kgf*cm | ft.*lbf | |||
|---|---|---|---|---|---|---|
| Drive plate and ring gear sub-assembly x Crankshaft | 88 | 897 | 65 | |||
| Part Tightened | N*m | kgf*cm | ft.*lbf | in.*lbf | |||
|---|---|---|---|---|---|---|---|
| No. 1 engine hanger and No. 2 engine hanger x Cylinder head sub-assembly | 43 | 438 | 32 | ||||
| Engine mounting insulator sub-assembly RH x Vehicle | 72 | 734 | 53 | ||||
| Air conditioner tube and accessory assembly x Engine mounting insulater sub-assembly RH and vehicle | Bolt | 9.8 | 100 | 87 | |||
| Nut | 5.4 | 55 | 48 | ||||
| No. 2 earth wire x Engine mounting insulator sub-assembly RH and vehicle | 10.5 | 107 | 8 | ||||
| Engine mounting insulator LH x Vehicle | 42 | 428 | 31 | ||||
| Wire harness clamp bracket x Cylinder head sub-assembly | 39 | 398 | 29 | ||||
| Front suspension crossmember sub-assembly x Vehicle | 141 | 1438 | 104 | ||||
| Engine mounting insulator LH x Engine mounting bracket LH | 44 | 449 | 32 | ||||
| Engine mounting insulator sub-assembly RH x Engine mounting bracket RH | Bolt | 72 | 734 | 53 | |||
| Nut | 41 | 418 | 30 | ||||
| Battery clamp sub-assembly x Vehicle | 15.4 | 157 | 11 | ||||
| Engine wire x Transaxle assembly | 8.5 | 87 | 75 | ||||
| Engine wire x Positive (+) battery terminal | 7.6 | 77 | 67 | ||||
| Engine wire x Battery clamp sub-assembly | 7.0 | 71 | 62 | ||||
| Engine wire x Vehicle | for Type A | 8.5 | 87 | 75 | |||
| for Type B | 10.5 | 107 | 8 | ||||
| No. 1 engine under cover x Vehicle | 7.5 | 76 | 66 | ||||
| Part Tightened | N*m | kgf*cm | ft.*lbf | in.*lbf | |||
|---|---|---|---|---|---|---|---|
| Stiffening crankcase stud bolt x Cylinder block sub-assembly | 5.0 | 51 | 44 | ||||
| Stud bolt x Cylinder block sub-assembly | 5.0 | 51 | 44 | ||||
| Stiffening crankcase assembly x Cylinder block sub-assembly | 21 | 214 | 15 | ||||
| No. 2 oil pan sub-assembly x Stiffening crankcase assembly | 10 | 102 | 7 | ||||
| Oil pan drain plug x No. 2 oil pan sub-assembly | 37 | 377 | 27 | ||||
| No. 1 taper screw plug x Cylinder block sub-assembly | No. 1 taper screw plug (A) | 25 | 255 | 18 | |||
| No. 1 taper screw plug (B) | 43 | 438 | 32 | ||||
| Stud bolt x Camshaft housing sub-assembly | 9.5 | 97 | 84 | ||||
| No. 1 Chain Vibration Damper x Cylinder block sub-assembly | 21 | 214 | 15 | ||||
| Oil pump drive shaft gear x Nut | 28 | 286 | 21 | ||||
| No. 1 generator bracket x Cylinder block sub-assembly | 24 | 245 | 18 | ||||
| Stud bolt x Water inlet housing | 5.0 | 51 | 44 | ||||
| Water inlet housing x Timing chain cover sub-assembly | 10 | 102 | 7 | ||||
| Timing chain cover sub-assembly x Engine water pump assembly | 21 | 214 | 15 | ||||
| Timing chain cover sub-assembly x Engine assembly | Bolt (A), (E) | 25.5 | 260 | 19 | |||
| Bolt (B) | 51 | 520 | 38 | ||||
| Bolt (C) | 51 | 520 | 38 | ||||
| Bolt (D) | 10 | 102 | 7 | ||||
| No. 1 Chain Tensioner Assembly x Timing chain cover sub-assembly | 12 | 122 | 9 | ||||
| Cylinder head cover sub-assembly x Cylinder head sub-assembly | 10 | 102 | 7 | ||||
| Engine cover joint x Cylinder head cover sub-assembly | 10 | 102 | 7 | ||||
| V-ribbed belt tensioner assembly x Engine assembly | 21 | 214 | 15 | ||||
| Wire harness clamp bracket x Cylinder block sub-assembly | 15 | 153 | 11 | ||||
| Wire harness clamp bracket x Cylinder head cover sub-assembly | Bolt (A) | 10 | 102 | 7 | |||
| Bolt (B) | 8.0 | 82 | 71 | ||||
| No. 1 vacuum pump bracket x Camshaft housing sub-assembly | 21 | 214 | 15 | ||||
| No. 1 Water by-pass pipe x Cylinder block sub-assembly | 21 | 214 | 15 | ||||
| No. 3 Water by-pass pipe x Cylinder block sub-assembly | 10 | 102 | 7 | ||||
| No. 2 generator bracket x Cylinder head sub-assembly | 25 | 255 | 18 | ||||
| Drive shaft bearing bracket x Cylinder block sub-assembly | 63.7 | 650 | 47 | ||||
| Oil level dipstick guide x Cylinder block sub-assembly | 21 | 214 | 15 | ||||
| Duty vacuum switching valve x Cylinder head cover sub-assembly | 10 | 102 | 7 | ||||
| Wire harness clamp bracket x cylinder head cover sub-assembly | Bolt A | 10 | 102 | 7 | |||
| Bolt B | 8 | 82 | 71 | ||||
| Wire harness clamp bracket x Intake manifold | 15 | 153 | 11 | ||||
| Part Tightened | N*m | kgf*cm | ft.*lbf | in.*lbf | |||
|---|---|---|---|---|---|---|---|
| Stud bolt x Cylinder head sub-assembly | Bolt (A) | 9.5 | 97 | 84 | |||
| Bolt (B) | 9.5 | 97 | 84 | ||||
| No. 2 straight screw plug x Cylinder head sub-assembly | 44 | 449 | 32 | ||||
| Part Tightened | N*m | kgf*cm | ft.*lbf | in.*lbf | |||
|---|---|---|---|---|---|---|---|
| Connecting rod cap x Connecting rod | 1st | 20 | 204 | 15 | |||
| 2nd | Turn 90° | ||||||
| Stud bolt x Cylinder block sub-assembly | 5.0 | 51 | 44 | ||||
| No. 1 oil nozzle sub-assembly x Cylinder block sub-assembly | 10 | 102 | 7 | ||||
| Crankshaft bearing cap x Cylinder block sub-assembly | 1st | 40 | 408 | 30 | |||
| 2nd | Turn 90° | ||||||
| No. 1 ventilation case x Cylinder block sub-assembly | 10 | 102 | 7 | ||||