Home › General › MAINTENANCE › 3ZR-FAE DRIVE BELT
RM32H0E _V1 General _059503 MAINTENANCE _0292820 3ZR-FAE DRIVE BELT A

MAINTENANCE  3ZR-FAE DRIVE BELT  REMOVAL  


PROCEDURE

Hide 51443C 1.REMOVE REAR ENGINE UNDER COVER RH

a.
A390449

Remove the 2 screws, 6 clips and rear engine under cover RH from the vehicle.


Hide 16361A 2.REMOVE FAN AND GENERATOR V BELT

a.
A313142C02
2.083,1.427 2.25,1.427 2.25,1.427 2.583,1.094 true 2.031,2.75 2.333,1.833 2.333,1.833 2.5,1.833 true 0.833,3.667 1,3.667 1,3.667 1.76,2.906 true 0.656,1.208 1.188,0.615 1.188,0.615 1.479,0.615 true 0.552,0.906 1.01,0.406 1.01,0.406 1.229,0.406 true 1.854,1.333 2.063,1.51 0.208,0.177 10 true *a 2.542,1.75 2.698,1.948 0.156,0.198 10 false A 0.698,3.583 0.854,3.781 0.156,0.198 10 false B 1.26,0.313 1.469,0.49 0.208,0.177 10 true *c 1.51,0.521 1.719,0.698 0.208,0.177 10 true *b
*a 5 mm Bi-hexagon Wrench
*b Hole
*c Gap


Attach a wrench to the hexagonal portion (A) or (B) of the V-ribbed belt tensioner assembly as shown in the illustration.


b.

Rotate the V-ribbed belt tensioner assembly clockwise to align the hole with the gap, and then insert a 5 mm bi-hexagon wrench into the hole and gap to secure the V-ribbed belt tensioner assembly.


c.

Remove the fan and generator V belt from the V-ribbed belt tensioner assembly.