Home › Vehicle Interior › HEATING / AIR CONDITIONING › BLOWER UNIT (for VALEO Made)
RM32H0E _58 Vehicle Interior _059841 HEATING / AIR CONDITIONING _0293720 BLOWER UNIT(for VALEO Made) A

HEATING / AIR CONDITIONING  BLOWER UNIT(for VALEO Made)  DISASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

Make sure to perform initialization after replacing the No. 1 blower damper servo sub-assembly. If initialization is not performed, the air conditioner unit assembly will not perform properly as the air conditioning amplifier assembly will not be able to recognize the position of the No. 1 blower damper servo sub-assembly.


Hide 88899M 2.REMOVE AIR FILTER COVER PLATE

a.
I112389C01
0,0 0,0 false
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)


Disengage the claw and guides to remove the air filter cover plate as shown in the illustration.


Hide 87139C 3.REMOVE CLEAN AIR FILTER

a.
I112390C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the clean air filter as shown in the illustration.


Hide 87103B 4.REMOVE BLOWER MOTOR WITH FAN SUB-ASSEMBLY (for Single Type)

a.

Disconnect the connector.


b.
I112391

Remove the 3 screws and blower motor with fan sub-assembly.


Hide 87130K 5.REMOVE NO. 1 BLOWER DAMPER SERVO SUB-ASSEMBLY (for Dual Type)

a.
I113439C01
0,0 0,0 false
V113147

Remove in this Direction


Turn the No. 1 blower damper servo sub-assembly to disengage the claw as shown in the illustration.


b.
I113440C02
0,0 0,0 false
V113147

Remove in this Direction


Remove the No. 1 blower damper servo sub-assembly as shown in the illustration.


Hide 88508C 6.REMOVE AIR FILTER SUB-ASSEMBLY (for Dual Type)

a.
I113443

Remove the 4 screws and the air filter sub-assembly.


Hide 87138C 7.REMOVE BLOWER RESISTOR (for Dual Type)

a.
I113444C02
0,0 0,0 false
V113147

Remove in this Direction


Disengage the guides and remove the blower resister as shown in the illustration.


Hide 87130K 8.REMOVE NO. 1 BLOWER DAMPER SERVO SUB-ASSEMBLY (for Single Type)

a.
I113774

Disconnect the damper servo link.


b.
I113775C01
0,0 0,0 false
V113147

Remove in this Direction


Turn the No. 1 blower damper servo sub-assembly to disengage the claw as shown in the illustration.


c.
I113777C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the No. 1 blower damper servo sub-assembly as shown in the illustration.


Hide 88508C 9.REMOVE AIR FILTER SUB-ASSEMBLY (for Single Type)

a.
I113827

Remove the 2 screws.


b.

Disengage the guides to remove the air filter sub-assembly.


Hide 87138C 10.REMOVE BLOWER RESISTOR

a.
I113779C02
0,0 0,0 false
V113147

Remove in this Direction


Disengage the guides and remove the blower resister as shown in the illustration.