Use the same procedure for LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
85530
1.REMOVE NO. 1 POWER OUTLET SOCKET ASSEMBLY
85535B
2.REMOVE NO. 1 POWER OUTLET SOCKET COVER
58923A
3.REMOVE CONSOLE REAR END PANEL
|
Remove in this Direction |
Using a moulding remover A, disengage the clips to remove the console rear end panel as shown in the illustration.
58985
4.REMOVE CONSOLE BOX RETAINER
|
Remove in this Direction |
Disengage the claws to remove the console box retainer as shown in the illustration.
58911A
5.REMOVE NO. 1 BOX SIDE PANEL
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Disengage the claws and guides to remove the No. 1 box side panel as shown in the illustration.
58912C
6.REMOVE NO. 2 BOX SIDE PANEL
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Disengage the claws and guides to remove the No. 2 box side panel as shown in the illustration.
58905
7.REMOVE CONSOLE COMPARTMENT DOOR SUB-ASSEMBLY
Remove the 4 screws.
Disengage the guides to remove the console compartment door sub-assembly.