22204
1.INSPECT MASS AIR FLOW METER
Perform "Inspection After Repair" after replacing the mass air flow meter.
Click hereEngine / Hybrid System>3ZR-FAE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION
Read the value using the GTS (MAF).
Perform the inspection of the mass air flow meter while it is installed to the air cleaner cap sub-assembly (installed to the vehicle).
Connect the GTS to the DLC3.
Start the engine.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Data List / MAF.
| Tester Display |
|---|
| MAF |
Wait for 30 seconds, and read the value on the GTS.
| Tester Display | Condition | Specified Condition |
|---|---|---|
| MAF | Idling (engine warmed up) | 1.0 to 3.0 gm/sec |
| 3000 rpm (Running without load) | 5.0 to 10.0 gm/sec |
If the result is not as specified, replace the mass air flow meter.
If the result is within the specified range, inspect the mass air flow meter.
Click hereEngine / Hybrid System>3ZR-FAE (ENGINE CONTROL)>MASS AIR FLOW METER>INSPECTION
22204
2.CLEAN MASS AIR FLOW METER SUB-ASSEMBLY
If the mass air flow meter sub-assembly is removed and installed 10 times or more, the thread of the hole of the mass air flow meter sub-assembly may be damaged. Therefore, do not loosen the screws of the mass air flow meter sub-assembly.
Remove the air cleaner cap sub-assembly.
| *1 | Mass Air Flow Meter Sub-assembly |
| *a | Air Blow Gun |
| *b | 10 mm (0.394 in.) |
| *c | Airflow Hole |
Clean the mass air flow meter sub-assembly.
Do not contact the mass air flow meter sub-assembly with the nozzle of the air blow gun.
Do not insert the nozzle of the air blow gun into the airflow hole.
| *a | Air Blow Duration |
| *b | 3 to 6 Seconds |
| *c | 1 Second |
| *d | Air Blowing |
| *e | Air Stopped |
Using an air blow gun, clean the hole of the mass air flow meter sub-assembly by applying approximately 10 intermittent bursts of air to the airflow hole at a pressure of approximately 392 to 981 kPa (4.0 to 10.0 kgf/cm2, 57 to 142 psi).
Apply 5 intermittent bursts of air to the airflow hole at 2 locations.
Install the air cleaner cap sub-assembly.
3.PERFORM INITIALIZATION
Perform "Inspection After Repair" after replacing the mass air flow meter.
Click hereEngine / Hybrid System>3ZR-FAE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION