Home › Engine / Hybrid System › 3ZR-FAE (ENGINE CONTROL) › MANIFOLD ABSOLUTE PRESSURE SENSOR
RM32H0E _51 Engine / Hybrid System _059607 3ZR-FAE ENGINE CONTROL _0293881 MANIFOLD ABSOLUTE PRESSURE SENSOR G

3ZR-FAE ENGINE CONTROL  MANIFOLD ABSOLUTE PRESSURE SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89421 1.INSPECT VACUUM SENSOR ASSEMBLY (MANIFOLD ABSOLUTE PRESSURE SENSOR)

a.
A248180C84
0.531,2.063 0.958,2.365 0.427,0.302 1.469,2.354 1.104,2.917 true 1.698,2.385 1.698,2.917 true 1.979,2.354 2.333,2.875 true 0.281,0.188 0.677,0.406 0.396,0.219 10 false *a 0.635,2.135 1.021,2.313 0.385,0.177 10 false C2 2.26,2.927 2.75,3.198 0.49,0.271 10 false VC 1.573,2.938 2.042,3.135 0.469,0.198 10 false PIM 0.99,2.938 1.26,3.125 0.271,0.188 10 false E2
*a Front view of wire harness connector
(to Vacuum Sensor Assembly (Manifold Absolute Pressure Sensor))


Check the terminal voltage.

i.

Disconnect the vacuum sensor assembly (manifold absolute pressure sensor) connector from the vacuum sensor assembly (manifold absolute pressure sensor).


ii.

Turn the ignition switch to ON.


iii.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
C2-3 (VC) - C2-1 (E2) Ignition switch ON 4.75 to 5.25 V
C2-2 (PIM) - C2-1 (E2) Ignition switch ON 3.0 to 5.25 V


If the result is not as specified, there may be an open or short in the VC or E2 circuit.



b.

Check the intake manifold pressure.

i.

Connect the GTS to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the GTS on.


iv.

Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / MAP.

Powertrain > Engine and ECT > Data List
Tester Display
MAP
50003 234 4

v.

Read the values displayed on the GTS.

OK:

Equivalent to atmospheric pressure.


HINT:
·

Standard atmospheric pressure is 101 kPa(abs) [758 mmHg(abs)].

·

For every 100 m (328 ft.) increase in altitude, pressure drops by 1 kPa (7.5 mmHg). This varies by weather.




vi.

While applying a vacuum of 67 kPa(abs) [503 mmHg(abs)] to the vacuum sensor assembly (manifold absolute pressure sensor) using a vacuum pump, measure the intake manifold pressure.

OK:

23 to 38 kPa(abs) [173 to 285 mmHg(abs)]


HINT:

If the result is not as specified, replace the vacuum sensor assembly (manifold absolute pressure sensor).