Home › Engine / Hybrid System › 3ZR-FAE (ENGINE CONTROL) › AIR FUEL RATIO SENSOR
RM32H0E _51 Engine / Hybrid System _059607 3ZR-FAE ENGINE CONTROL _0293882 AIR FUEL RATIO SENSOR A

3ZR-FAE ENGINE CONTROL  AIR FUEL RATIO SENSOR  INSTALLATION  


PROCEDURE

Hide 89467B 1.INSTALL AIR FUEL RATIO SENSOR

HINT:

Perform "Inspection After Repair" after replacing the air fuel ratio sensor.

Click hereEngine / Hybrid System>3ZR-FAE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION


a.
A393521C01
1.479,1.75 1.865,1.427 true 1.125,1.667 1.458,1.854 0.333,0.188 10 true SST 0.458,0.938 0.688,1.135 0.229,0.198 10 true *a
*a Torque Wrench Fulcrum Length


Using SST, install the air fuel ratio sensor to the exhaust manifold.

SST
09224-00012  

Torque:
Specified tightening torque : 44 N*m (449 kgf*cm, 32 ft.*lbf)

NOTICE:

If the air fuel ratio sensor has been struck or dropped, replace it.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)):

39 N*m (398 kgf*cm, 29 ft.*lbf)




b.

Engage the 2 clamps.


c.

Connect the air fuel ratio sensor connector.


Hide 58151 2.INSTALL NO. 1 FRONT FLOOR HEAT INSULATOR

a.

Install the No. 1 front floor heat insulator to the vehicle with the 3 nuts.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


Hide 17410 3.INSTALL FRONT EXHAUST PIPE ASSEMBLY (TWC: Front and Rear Catalyst)

Hide 5.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing the air fuel ratio sensor.

Click hereEngine / Hybrid System>3ZR-FAE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION