Home › Engine / Hybrid System › 8NR-FTS (FUEL) › FUEL PUMP (for 2WD)
RM32H0E _51 Engine / Hybrid System _059909 8NR-FTS FUEL _0293903 FUEL PUMP(for 2WD) G

8NR-FTS FUEL  FUEL PUMP(for 2WD)  INSPECTION  


PROCEDURE

Hide 23221 1.INSPECT FUEL PUMP

a.
A288171N02
1.298,1.033 1.468,1.190 0.170,0.158 10 1 2.02,1.033 2.190,1.190 0.170,0.158 10 2 1.596,0.554 1.387,1.01 false 1.829,0.554 2.037,1.01 false

Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 0.2 to 3.0 Ω


If the result is not as specified, replace the fuel pump.



b.

Check the operation.

i.

Apply battery voltage to both terminals. Check that the fuel pump operates.

NOTICE:
·

Perform this test within 10 seconds to prevent the coil from burning out.

·

Keep the fuel pump as far away from the battery as possible.

·

Always switch the voltage on and off at the battery side, not the fuel pump side.



If the fuel pump does not operate, replace the fuel pump.