Home › Vehicle Interior › LIGHTING (INT) › VANITY LIGHT SWITCH
RM32H0E _58 Vehicle Interior _060018 LIGHTING (INT) _0294071 VANITY LIGHT SWITCH G

LIGHTING (INT)  VANITY LIGHT SWITCH  INSPECTION  


PROCEDURE

Hide 74320 1.INSPECT VISOR ASSEMBLY LH

a.
E224621C15
1.333,2.99 1.125,2.667 true 3,3.146 3,2.813 false 2.333,3.917 2.333,3.583 false 0.896,0.115 1.167,0.323 0.271,0.208 10 false *a 2.958,3.198 3.229,3.406 0.271,0.208 10 false *b 2.271,3.958 2.542,4.167 0.271,0.208 10 false *c 0.938,2.552 1.208,2.76 0.271,0.208 10 false *d
*a Component without harness connected
(Visor Assembly LH)
*b Visor up
*c Visor down
*d Mirror Cover


Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Visor up 10 kΩ or higher
1 - 2 Mirror cover fully closed with visor down 10 kΩ or higher
1 - 2 Mirror cover fully open with visor down Below 1 Ω


If the result is not as specified, replace the visor assembly LH.



Hide 74310 2.INSPECT VISOR ASSEMBLY RH

a.
E224622C15
1.969,2.917 2.385,2.5 true 1.167,3.917 1.167,3.583 false 0.542,3.156 0.542,2.823 false 0.896,0.125 1.167,0.333 0.271,0.208 10 false *a 0.49,3.208 0.76,3.417 0.271,0.208 10 false *b 1.115,3.948 1.385,4.156 0.271,0.208 10 false *c 2.427,2.375 2.698,2.583 0.271,0.208 10 false *d
*a Component without harness connected
(Visor Assembly RH)
*b Visor up
*c Visor down
*d Mirror Cover


Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Visor up 10 kΩ or higher
1 - 2 Mirror cover fully closed with visor down 10 kΩ or higher
1 - 2 Mirror cover fully open with visor down Below 1 Ω


If the result is not as specified, replace the visor assembly RH.