Home › Engine / Hybrid System › 3ZR-FAE (LUBRICATION) › OIL PUMP
RM32H0E _51 Engine / Hybrid System _060036 3ZR-FAE LUBRICATION _0294094 OIL PUMP G

3ZR-FAE LUBRICATION  OIL PUMP  INSPECTION  


PROCEDURE

Hide 1.INSPECT OIL PUMP RELIEF VALVE

a.
A315718

Coat the oil pump relief valve with engine oil, then check that it falls smoothly into the valve hole by its own weight.

If the oil pump relief valve does not fall smoothly, replace the oil pump assembly.


Hide 15100 2.INSPECT OIL PUMP ASSEMBLY

a.

Check the side clearance.

i.
A173780

Using a feeler gauge and precision straightedge, measure the clearance between the oil pump drive rotor, oil pump driven rotor and precision straightedge.

Standard Side Clearance:

0.085 to 0.135 mm (0.00335 to 0.00531 in.)


Maximum Side Clearance:

0.16 mm (0.00629 in.)


If the side clearance is greater than the maximum, replace the oil pump assembly.



b.

Check the tip clearance.

i.
A173781

Using a feeler gauge, measure the clearance between the oil pump drive rotor and oil pump driven rotor tips.

Standard Tip Clearance:

0.08 to 0.16 mm (0.00315 to 0.00629 in.)


Maximum Tip Clearance:

0.35 mm (0.0137 in.)


If the tip clearance is greater than the maximum, replace the oil pump assembly.



c.

Check the body clearance.

i.
A173782

Using a feeler gauge, measure the clearance between the oil pump driven rotor and oil pump body.

Standard Body Clearance:

0.12 to 0.19 mm (0.00473 to 0.00748 in.)


Maximum Body Clearance:

0.325 mm (0.0127 in.)


If the body clearance is greater than the maximum, replace the oil pump assembly.