Home › Engine / Hybrid System › 8NR-FTS (LUBRICATION) › OIL PUMP › 2016.10–2019.09
RM32H0E _51 Engine / Hybrid System _060037 8NR-FTS LUBRICATION _0294100 OIL PUMP A

8NR-FTS LUBRICATION  OIL PUMP  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the oil pump assembly removal/ installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link

*1: When performing learning using the GTS

Click here(Click here)

*2: w/ Stop and start system

Disconnect cable from negative battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Pre-collision syatem
Initialize back door lock Power door lock control system (Click here)
Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2 Stop and start system (Click here)
Replacement of CVT fluid ATF thermal degradation estimate reset The value of the Data List item "ATF thermal Degradation Estimate" is not estimated correctly for K313
(Click here)
for K313F
(Click here)
Front wheel alignment adjustment Perform the following procedures in the order shown:
1.

Clear zero point calibration data and store system information

2.

Perform yaw rate and acceleration sensor zero point calibration and store system information


·

VSC disabled or malfunctions

·

DTCs are stored

·

Slip indicator light illuminates

·

ABS warning light illuminates


(Click here)

PROCEDURE

Hide 13506 1.REMOVE CHAIN SUB-ASSEMBLY

Hide 13521 2.REMOVE CRANKSHAFT TIMING SPROCKET

Hide 13507 3.REMOVE NO. 2 CHAIN SUB-ASSEMBLY

Hide 12102A 4.REMOVE NO. 2 OIL PAN SUB-ASSEMBLY

Hide 15100 5.REMOVE OIL PUMP ASSEMBLY

a.
A353070

Remove the 3 bolts and oil pump assembly from the stiffening crankcase assembly.