Home › Audio / Visual / Telematics › TELEMATICS › MAYDAY SWITCH
RM32H0E _56 Audio / Visual / Telematics _060052 TELEMATICS _0294138 MAYDAY SWITCH G

TELEMATICS  MAYDAY SWITCH  INSPECTION  


PROCEDURE

Hide 86750A 1.INSPECT MAYDAY SWITCH ASSEMBLY

a.
E358820C01
1.125,2.698 0.76,3.052 true 1.469,2.708 1.198,3.063 true 1.792,2.729 1.698,3.063 true 2.146,2.708 2.26,3.021 true 2.333,2.719 2.698,3.01 true 1.469,1.281 1.104,1.635 true 1.979,1.271 2.365,1.604 true 2.469,0.365 1.865,0.865 true 0.104,0.083 0.417,0.24 0.313,0.156 10 false *a 0.573,3.073 0.927,3.25 0.354,0.177 10 false GND 1.042,3.083 1.396,3.26 0.354,0.177 10 false IND2 2.146,3.052 2.5,3.229 0.354,0.177 10 false IND1 2.615,3.031 2.969,3.208 0.354,0.177 10 false SIG1 1.51,3.083 1.969,3.26 0.458,0.177 10 false SLED 1,1.656 1.313,1.813 0.313,0.156 10 false *c 2.354,1.646 2.667,1.802 0.313,0.156 10 false *d 2.521,0.26 2.833,0.417 0.313,0.156 10 false *b
*a Component without harness connected
(Mayday Switch Assembly)
*b SOS Switch
*c Green Indicator
*d Red Indicator


Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
8 (SIG1) - 1 (GND) Mayday switch is pushed 78 to 86 Ω
8 (SIG1) - 1 (GND) Mayday switch is not pushed 392 to 432 Ω


If the resistance is not as specified, replace the mayday switch assembly.



b.

Check the switch illumination.

i.

Apply battery voltage to the mayday switch assembly and check that the illumination comes on.

OK:
Battery Connection Specified Condition
Battery positive (+) → 5 (SLED)
Battery negative (-) → 1 (GND)
SOS switch comes on


If the resistance is not as specified, replace the mayday switch assembly.



c.

Check the indicator illumination.

i.

Apply battery voltage to the mayday switch assembly and check that the illumination comes on.

OK:
Battery Connection Specified Condition
Battery positive (+) → 7 (IND1)
Battery negative (-) → 1 (GND)
Red indicator comes on
Battery positive (+) → 3 (IND2)
Battery negative (-) → 1 (GND)
Green indicator comes on


If the resistance is not as specified, replace the mayday switch assembly.