Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SEAT POSITION SENSOR › 2016.10–2019.09
RM32H0E _58 Vehicle Interior _060061 SUPPLEMENTAL RESTRAINT SYSTEMS _0294203 SEAT POSITION SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  SEAT POSITION SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the seat position airbag sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Pre-collision system
Initialize back door lock Power door lock control system (Click here)
Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2 Stop and start system (Click here)

*1: When performing learning using the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>SIMPLE INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION

*2: w/ Stop and start system

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The following procedure is for LHD vehicles.



PROCEDURE

Hide 1.REMOVE FRONT SEAT ASSEMBLY

Hide 72277A 2.REMOVE SEAT SLIDE POSITION SENSOR PROTECTOR

a.
B458404

Disengage the clamp and disconnect the connector.


b.
B458405C01
0,0 0,0 false
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)


Pull the seat slide position sensor protector in the direction indicated by the arrow (1), to disengage the pin, and then slide the seat slide position sensor protector in the direction indicated by the arrows (2) shown in the illustration to remove it.


Hide 89178A 3.REMOVE SEAT POSITION AIRBAG SENSOR (for 6 Way Seat Type)

a.
B458406

Using a T30 "TORX" socket wrench, remove the "TORX" bolt and seat position airbag sensor.


Hide 89178A 4.REMOVE SEAT POSITION AIRBAG SENSOR (for 4 Way Seat Type)

a.
B458522

Remove the nut and seat position airbag sensor.