Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG CUT-OFF SWITCH
RM32H0E _58 Vehicle Interior _060061 SUPPLEMENTAL RESTRAINT SYSTEMS _0294204 AIRBAG CUT-OFF SWITCH G

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG CUT-OFF SWITCH  INSPECTION  


PROCEDURE

Hide 69065A 1.INSPECT AIRBAG CUT OFF SWITCH CYLINDER SUB-ASSEMBLY

a.

Check the resistance.

i.
C261687C15
2.302,1.031 2.75,0.75 true 2.313,1.146 2.76,1.427 true 0.073,0.063 0.354,0.365 0.281,0.302 10 false *a 2.781,0.635 3.25,0.979 0.469,0.344 10 false PMC+ 2.729,1.448 3.198,1.792 0.469,0.344 10 false PMC-
*a Component without harness connected
(Airbag Cut Off Switch Cylinder Sub-assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
2 (PMC+) - 1 (PMC-) Cut off switch in ON position 360 to 440 Ω
2 (PMC+) - 1 (PMC-) Cut off switch in OFF position 90 to 110 Ω


If the result is not as specified, replace the airbag cut off switch cylinder sub-assembly.