Home › Vehicle Interior › SEAT BELT › OCCUPANT DETECTION SENSOR
RM32H0E _58 Vehicle Interior _060065 SEAT BELT _0294233 OCCUPANT DETECTION SENSOR G

SEAT BELT  OCCUPANT DETECTION SENSOR  INSPECTION  


PROCEDURE

Hide 71511S 1.INSPECT OCCUPANT DETECTION SENSOR (SEPARATE TYPE FRONT SEAT CUSHION PAD)

a.

Check the resistance.

i.
B378697C12
0.177,0.156 0.49,0.313 0.313,0.156 10 false *a
*a Component without harness connected
(Occupant Detection Sensor (Separate Type Front Seat Cushion Pad))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 3 Front passenger side seat occupied Below 100 Ω
1 - 3 Front passenger side seat not occupied 1 MΩ or higher


If the result is not as specified, replace the occupant detection sensor (separate type front seat cushion pad).