Home › Vehicle Interior › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY › 2016.10–2019.09
RM32H0E _58 Vehicle Interior _060065 SEAT BELT _0294234 FRONT SEAT INNER BELT ASSEMBLY A

SEAT BELT  FRONT SEAT INNER BELT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the front seat inner belt assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Pre-collision system
Initialize back door lock Power door lock control system (Click here)
Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2 Stop and start system (Click here)

*1: When performing learning using the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>SIMPLE INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION

*2: w/ Stop and start system

CAUTION:
·
B458500

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION

·

Wear protective gloves. Sharp areas on the parts may injure your hands.



HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the driver side and front passenger side.

·

The procedure listed below is for the driver side.



PROCEDURE

Hide 1.REMOVE FRONT SEAT ASSEMBLY

Hide 73240 2.REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)

a.
B458462

Disengage the clamp and claw.


b.

w/ Vertical Adjuster:

i.
B458411

Disengage the clamps.


ii.

Remove the nut and front seat inner belt assembly.



c.

w/o Vertical Adjuster:

i.
B458412

Disengage the clamp.


ii.

Remove the nut and front seat inner belt assembly.



d.

Remove the front seat belt anchor plate.


Hide 73230 3.REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side)

a.
B458463

Disconnect the connector.


b.

Disengage the clamps and claw.


c.
B458413

Disengage the clamp.


d.

Remove the nut and front seat inner belt assembly.


e.

Remove the front seat belt anchor plate.