73380A
1.INSPECT REAR SEAT INNER BELT ASSEMBLY (w/ Seat Belt Warning System)
Check the resistance.
| *a | Component without harness connected
(Rear Seat Inner Belt Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| M31-5 (RBR+) - M31-4 (RBR-) | Rear seat inner belt assembly unfastened | Below 1 Ω |
| Rear seat inner belt assembly fastened | 10 kΩ or higher |
If the result is not as specified, replace the rear seat inner belt assembly.