COMBINATION METER ASSEMBLY
Disconnect the combination meter assembly connectors.
Measure the voltage on the wire harness side connector according to the value(s) in the table below.
| Terminal No. | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| F4-39 (IG+) - Body ground | P - Body ground | Ignition switch signal | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V | |||
| F4-40 (B) - Body ground | SB - Body ground | Battery | Always | 11 to 14 V |
| F5-1 (B) - Body ground | SB - Body ground | Battery | Always | 11 to 14 V |
If the result is not as specified, there may be a malfunction in the wire harness.
Reconnect the combination meter assembly connectors.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| F4-1 (RLMT) - Body ground*1 | L - Body ground | Rear seat belt LH warning light signal | Rear seat belt LH fastened within 30 seconds of opening rear door with ignition switch ON | 11 to 14 V |
| Rear seat belt LH unfastened within 30 seconds of opening rear door with ignition switch ON | Below 1 V | |||
| F4-2 (RCMT) - Body ground*1 | V - Body ground | Rear seat center belt warning light signal | Rear seat center belt fastened within 30 seconds of opening rear door with ignition switch ON | 11 to 14 V |
| Rear seat center belt unfastened within 30 seconds of opening rear door with ignition switch ON | Below 1 V | |||
| F4-3 (RRMT) - Body ground*1 | W - Body ground | Rear seat belt RH warning light signal | Rear seat belt RH fastened within 30 seconds of opening rear door with ignition switch ON | 11 to 14 V |
| Rear seat belt RH unfastened within 30 seconds of opening rear door with ignition switch ON | Below 1 V | |||
| F4-4 (INT) - Body ground*2 | B - Body ground | Tire pressure warning light signal | Ignition switch ON, tire pressure warning light off | Below 1 V |
| Ignition switch ON, tire pressure warning light on | 11 to 14 V | |||
| F4-5 (SI) - Body ground | GR - Body ground | Speed signal for other system (Input) | Ignition switch ON, wheel being rotated | Pulse generation (See waveform 1) |
| F4-6 (+S) - Body ground | V - Body ground | Speed signal for other system (Output) | Ignition switch ON, wheel being rotated | Pulse generation (See waveform 1) |
| F4-7 (PKBI) - Body ground | GR - Body ground | Front passenger side seat belt buckle switch signal | Ignition switch ON, front passenger side seat belt fastened and front passenger seat occupied | 11 to 14 V |
| Ignition switch ON, front passenger side seat belt unfastened and front passenger seat occupied | Below 1 V | |||
| F4-9 (S) - Body ground*3 | G - Body ground | Engine oil pressure switch signal | Ignition switch ON, low engine oil level warning light on | Below 1 V |
| Ignition switch ON, low engine oil level warning light off | 11 to 14 V | |||
| F4-12 (SW) - Body ground | R - Body ground | Brake system warning light (red indicator) signal | Ignition switch ON, brake system warning light (red indicator) on | Below 1 V |
| Ignition switch ON, brake system warning light (red indicator) off | 11 to 14 V | |||
| F4-16 (FV) - Body ground | GR - Body ground | Fuel sender gauge (Power source) | Fuel F (full tank) → E (empty) | 4.5 to 5.5 V |
| F4-17 (WLVL) - Body ground*4 | LG - Body ground | Washer fluid level signal | Ignition switch ON washer fluid level not low | 11 to 14 V |
| Ignition switch ON washer fluid level low | Below 1 V | |||
| F4-21 (ET) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| F4-22 (FR2) - F4-15 (EE&B)*5 | B - BE | Fuel level signal | Ignition switch ON fuel level full | Below 1 V |
| Ignition switch ON fuel level low (fuel level warning light on) | 4.5 to 9 V | |||
| F4-23 (FR) - F4-15 (EE&B) | G - BE | Fuel level signal | Ignition switch ON fuel level full | Below 1 V |
| Ignition switch ON fuel level low (fuel level warning light on) | 4.5 to 9 V | |||
| F4-24 (MSD) - Body ground*1 | V - Body ground | Rear seat inner belt signal (LH side) | Ignition switch ON, rear LH seat belt unfastened | Below 1 V |
| Ignition switch ON, rear LH seat belt fastened | 11 to 14 V | |||
| F4-25 (MSTI) - Body ground*1 | BE - Body ground | Rear seat inner belt signal (Center) | Ignition switch ON, rear center seat belt unfastened | Below 1 V |
| Ignition switch ON, rear center seat belt fastened | 11 to 14 V | |||
| F4-26 (MSFM) - Body ground*1 | R - Body ground | Rear seat inner belt signal (RH side) | Ignition switch ON, rear RH seat belt unfastened | Below 1 V |
| Ignition switch ON, rear RH seat belt fastened | 11 to 14 V | |||
| F4-27 (OILW) - Body ground*9 | P - Body ground | Engine oil level signal | Ignition switch ON, engine oil level not low | 11 to 14 V |
| Ignition switch ON, engine oil level low | Below 1 V | |||
| F4-28 (MSM+) - Body ground | V - Body ground | Steering pad switch signal | Ignition switch ON, enter, trip and back switches on steering pad switch not pushed | 4.3 to 5.2 V |
| Ignition switch ON, enter switch on steering pad switch pushed | Below 0.6 V | |||
| Ignition switch ON, trip switch on steering pad switch pushed | 1.0 to 2.2 V | |||
| Ignition switch ON, back switch on steering pad switch pushed | 2.3 to 3.4 V | |||
| F4-31 (CANL) - Body ground | SB - Body ground | CAN communication line | - | - |
| F4-32 (CANH) - Body ground | V - Body ground | CAN communication line | - | - |
| F4-33 (MSSL) - Body ground*6 | GR - Body ground | Steering pad switch signal | Ignition switch ON, up, down, right and left switches on steering pad switch assembly not pushed | 4.3 to 5.2 V |
| Ignition switch ON, left switch on steering pad switch pushed | Below 0.6 V | |||
| Ignition switch ON, up switch on steering pad switch pushed | 1.0 to 2.2 V | |||
| Ignition switch ON, down switch on steering pad switch pushed | 2.3 to 3.4 V | |||
| Ignition switch ON, right switch on steering pad switch pushed | 3.4 to 4.5 V | |||
| F4-34 (TEMP) - Body ground | SB - Body ground | Ambient temperature sensor signal | Ambient temperature 25°C (77°F) | 1.6 to 1.8 Ω*5 |
| F4-35 (TX1+) - Body ground | P - Body ground | Ambient temperature sensor gauge signal | Always | Below 1 Ω |
| F4-36 (MSCH) - Body ground*7 | R - Body ground | CAN communication line | - | - |
| F4-37 (MSCL) - Body ground*7 | L - Body ground | CAN communication line | - | - |
| F5-2 (VCM) - Body ground*8 | GR - Body ground | Vacuum warning switch signal | Ignition switch ON, engine idle speed | Pulse generation |
| F5-3 (HAZ) - Body ground | W - Body ground | Hazard warning signal switch signal (Output) | Hazard warning signal switch off | 11 to 14 V |
| Hazard warning signal switch on | Below 1 V | |||
| F5-5 (TRNR) - Body ground | SB - Body ground | Rear turn signal light RH signal | Ignition switch ON, RH turn indicator light off | Below 1 V |
| Ignition switch ON, RH turn indicator light blinking | 11 to 14 V ←→ Below 1 V | |||
| F5-6 (TRNL) - Body ground | Y - Body ground | Rear turn signal light LH signal | Ignition switch ON, LH turn indicator light off | Below 1 V |
| Ignition switch ON, LH turn indicator light blinking | 11 to 14 V ←→ Below 1 V | |||
| F5-8 (SW) - Body ground | L - Body ground | Turn signal switch (full turn) signal | Headlight dimmer switch on (full turn) | Below 1 V |
| Headlight dimmer switch off | 11 to 14 V | |||
| F5-7 (LR) - Body ground | V - Body ground | Rear turn signal light RH signal | Ignition switch ON, RH turn indicator light off | Below 1 V |
| Ignition switch ON, RH turn indicator light blinking | 11 to 14 V ←→ Below 1 V | |||
| F5-9 (ER) - Body ground | P - Body ground | RH turn indicator light signal (Input) | Ignition switch ON, RH turn signal switch on | Below 1 V |
| Ignition switch ON, RH turn signal switch off | 11 to 14 V | |||
| F5-10 (EL) - Body ground | B - Body ground | LH turn indicator light signal (Input) | Ignition switch ON, LH turn signal switch on | Below 1 V |
| Ignition switch ON, LH turn signal switch off | 11 to 14 V | |||
| F5-13 (LL) - Body ground | G - Body ground | Rear turn signal light LH signal | Ignition switch ON, LH turn indicator light off | Below 1 V |
| Ignition switch ON, LH turn indicator light blinking | 11 to 14 V ←→ Below 1 V |
*1: w/ Rear Seat Belt Warning System
*2: w/ Tire Pressure Warning System
*3: for 3ZR-FAE
*4: w/ Washer Level Warning
*5: for AWD
*6: for Color TFT Type
*7: for Radio and Display Receiver Type
*8: w/ Vacuum Warning
*9: for 8NR-FTS
If the result is not as specified, the combination meter assembly may be malfunctioning.
Waveform 1 (Reference):
| Item | Condition |
|---|---|
| Tool setting | 5 V/DIV., 20 ms./DIV. |
| Vehicle condition | Ignition switch ON wheel being rotated |
When the system is functioning normally, one wheel revolution generates 4 pulses. As the vehicle speed increases, the width indicated by (A) in the illustration narrows.