Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT DRIVE SHAFT ASSEMBLY (for TMMT Made)
RM32H0E _52 Drivetrain _060137 DRIVE SHAFT / PROPELLER SHAFT _0294912 FRONT DRIVE SHAFT ASSEMBLY(for TMMT Made) G

DRIVE SHAFT / PROPELLER SHAFT  FRONT DRIVE SHAFT ASSEMBLY(for TMMT Made)  INSPECTION  


PROCEDURE

Hide 1.INSPECT FRONT DRIVE SHAFT ASSEMBLY (for 8NR-FTS)

a.
C287111

Check that there is no excessive play in the radial direction of the outboard joint.


b.

Check that the inboard joint slides smoothly in the thrust direction.


c.

Check that there is no excessive play in the radial direction of the inboard joint.


d.

Check the boots for damage.


e.
C213153C03
0.101,0.042 0.290,0.213 0.190,0.171 10 *a 0.101,2.706 0.290,2.877 0.190,0.171 10 *b 1.489,1.453 1.714,1.626 0.226,0.173 10 (A) 1.505,3.766 1.731,3.939 0.226,0.173 10 (A)
*a LH Side and RH Side, 2WD
*b RH Side, AWD


Check whether each drive shaft dimension (A) is within specification.

Dimension (A):
Drive Type LH Side RH Side
for 2WD 611.8 mm (2.01 ft.) 877.5 mm (2.88 ft.)
for AWD 611.8 mm (2.01 ft.) 872.6 mm (2.86 ft.)


NOTICE:

Keep the drive shaft assembly level during inspection.



Hide 2.INSPECT FRONT DRIVE SHAFT ASSEMBLY (for 3ZR-FAE)

a.
C287111

Check that there is no excessive play in the radial direction of the outboard joint.


b.

Check that the inboard joint slides smoothly in the thrust direction.


c.

Check that there is no excessive play in the radial direction of the inboard joint.


d.

Check the boots for damage.


e.
C213153C03
0.101,0.042 0.290,0.213 0.190,0.171 10 *a 0.101,2.706 0.290,2.877 0.190,0.171 10 *b 1.489,1.453 1.714,1.626 0.226,0.173 10 (A) 1.505,3.766 1.731,3.939 0.226,0.173 10 (A)
*a LH Side
*b RH Side


Check whether each drive shaft dimension (A) is within specification.

Dimension (A):
LH Side RH Side
590.5 mm (1.94 ft.) 887.1 mm (2.91 ft.)


NOTICE:

Keep the drive shaft assembly level during inspection.