Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT DRIVE SHAFT ASSEMBLY (for TMC Made)
RM32H0E _52 Drivetrain _060137 DRIVE SHAFT / PROPELLER SHAFT _0294913 FRONT DRIVE SHAFT ASSEMBLY(for TMC Made) G

DRIVE SHAFT / PROPELLER SHAFT  FRONT DRIVE SHAFT ASSEMBLY(for TMC Made)  INSPECTION  


PROCEDURE

Hide 1.INSPECT FRONT DRIVE SHAFT ASSEMBLY

a.
C295105

Check that there is no excessive play in the radial direction of the outboard joint.


b.

Check that the inboard joint slides smoothly in the thrust direction.


c.

Check that there is no excessive play in the radial direction of the inboard joint.


d.

Check the boots for damage.


e.
C295106E01
1.354,1.594 1.813,1.792 0.458,0.198 10 false (A)

Check whether each drive shaft dimension (A) is within specification.

Dimension (A):
LH Side 615.9 mm (2.02 ft.)
RH Side
(for 2WD)
870.9 mm (2.86 ft.)
RH Side
(for AWD)
876.5 mm (2.88 ft.)


NOTICE:

Keep the front drive shaft assembly level during inspection.