Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM
RM32H0E _54 Brake _060039 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0294918 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1419  Acceleration Sensor Internal Circuit  C1435  Yaw Rate Sensor Internal Circuit  


DESCRIPTION

These DTCs are stored when the skid control ECU (brake actuator assembly) receives an internal malfunction signal from the yaw rate and acceleration sensor (airbag sensor assembly).

DTC No. Detection Item DTC Detection Condition Trouble Area
C1419 Acceleration Sensor Internal Circuit With the +BS terminal voltage between 9.6 and 16.5 V, an acceleration sensor malfunction signal is received from the acceleration sensor. Acceleration sensor (airbag sensor assembly)
C1435 Yaw Rate Sensor Internal Circuit With the +BS terminal voltage between 9.6 and 16.5 V, a yaw rate sensor malfunction signal is received from the yaw rate sensor. Yaw rate sensor (airbag sensor assembly)

PROCEDURE

1.REPLACE AIRBAG SENSOR ASSEMBLY
a.

Replace the yaw rate and acceleration sensor (airbag sensor assembly).

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>REMOVAL

HINT:

If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>PROBLEM SYMPTOMS TABLE



Result:
Proceed to
NEXT



NEXT

END