Home › Brake › PARKING BRAKE › ELECTRIC PARKING BRAKE SYSTEM
RM32H0E _54 Brake _060043 PARKING BRAKE _0294919 ELECTRIC PARKING BRAKE SYSTEM D

PARKING BRAKE  ELECTRIC PARKING BRAKE SYSTEM  FREEZE FRAME DATA  


FREEZE FRAME DATA


HINT:
·

When a DTC is stored, the freeze frame data stores the current vehicle (sensor) state as.

·

The freeze frame data cannot be cleared or updated until the recorded DTCs are cleared.



Chassis > ABS/VSC/TRC/EPB
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Elapsed Time after Freeze Trigger Elapsed time after freeze trigger Min.: 0 msec, Max.: 510 msec - -
Number of IG ON Number of times ignition switch turned to ON after Freeze Frame Data stored 0 to 31 - -
Buzzer Meter buzzer ON or OFF OFF: Buzzer off No change
Stop Light SW Stop light switch ON or OFF ON: Brake pedal depressed
OFF: Brake pedal released
-
Parking Brake SW Parking brake switch ON or OFF ON: Parking brake applied
OFF: Parking brake released
-
Gear Position Gear position information P/N, R, 1st-8th, Fail or Not R Actual gear position for Continuously Variable Transaxle
Shift Lever Position Shift lever position information P/N, R, D/M, 1st-6th/B or Fail Actual shift lever position for Continuously Variable Transaxle
Operated System Operated system status Non, ABS, VSC, TRC, BA, HAB, Fail, PBA, PB, HA-CTRL, TSC, MCB, Sys Actual operated system Non: No operation is activated.
ABS: ABS is activated.
VSC: VSC is activated.
TRC: TRC is activated.
BA: BA is activated.
HAB: HAB is activated.*
Fail: Fail safe mode is activated.
PBA: PBA is activated.
PB: PB is activated.*
HA-CTRL: Hill-start assist control is activated.
TSC: Trailer sway control activated*
MCB: SCB is activated.*
Sys: System prohibit is activated.
Master Cylinder Sensor Master cylinder pressure sensor reading Min.: 0.00 V, Max.: 5.00 V Brake pedal released: 0.20 to 0.40 V Reading increases when brake pedal is depressed
M/C Sensor Grade Master cylinder pressure sensor change Min.: -30 MPa/s, Max.: 225 MPa/s Brake pedal released or pedal held at constant position: 0 MPa/s When brake pedal is being operated: Changes in proportion with the pedal movement speed
Yaw Rate Sensor Yaw rate sensor Min.: -128°/s, Max.: 127°/s Vehicle stopped: 0°/s
Turning right: -128 to 0°/s
Turning left: 0 to 127°/s
-
Lateral G Lateral G Min.: -25.10 m/s2, Max.: 24.90 m/s2 - During turning: Changes in proportion with lateral acceleration
Forward and Rearward G Forward and backward G Min.: - 25.10 m/s2, Max.: 24.90 m/s2 - During acceleration/deceleration: Changes in proportion with acceleration
FR Wheel Speed Front wheel speed sensor RH reading Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations
FL Wheel Speed Front wheel speed sensor LH reading Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations
RR Wheel Speed Rear wheel speed sensor RH reading Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations
RL Wheel Speed Rear wheel speed sensor LH reading Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations
Vehicle Speed Maximum wheel speed sensor reading Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations
Vehicle Speed Grade Vehicle speed grade Min.: -25.10 m/s2, Max.: 24.90 m/s2 Vehicle stopped: 0 m/s2 During driving: Changes in proportion with vehicle acceleration/deceleration
FR Wheel Direction Front wheel RH direction signal Forward or Back Forward: Forward
Back: Backward
-
FL Wheel Direction Front wheel LH direction signal Forward or Back Forward: Forward
Back: Backward
-
RR Wheel Direction Rear wheel RH direction signal Forward or Back Forward: Forward
Back: Backward
-
RL Wheel Direction Rear wheel LH direction signal Forward or Back Forward: Forward
Back: Backward
-
Real Engine Torque Actual engine torque Min.: -1024.0 Nm, Max.: 1023.0 Nm - -
Accelerator Opening Angle % Percentage of accelerator pedal opening angle Min.: 0.0%, Max.: 127.5% The accelerator pedal released: 0% During accelerator pedal operation: Changes in proportion with the pedal movement
Brake Pedal Load Sensing SW Brake pedal load sensing switch ON or OFF ON: Brake pedal depressed
OFF: Brake pedal released
-
Inspection Mode Inspection mode Other or Inspect Other: Normal mode
Inspect: Inspection mode
-
Steering Angle Sensor Steering angle sensor Min.: - 3276.8°, Max.: 3276.7° Left turn: Increase
Right turn: Decrease
-
TRC/VSC Off Mode TRC/VSC off mode Normal, TRC OFF, VSC Expert Mode, VSC OFF Normal: Normal mode
TRC OFF: TRC off mode
VSC OFF: VSC off mode
-
Vehicle Speed (Control Value) Vehicle speed
(control value)
Min.: 0.0 km/h (0.0 MPH)
Max.: 326.4 km/h (202.8 MPH)
- -
ECU +B1 Voltage skid control ECU
(brake actuator assembly) +B1 voltage
0.00 to 20.00 V 11 to 14 V -
RH Actuator Motor Input Voltage Parking brake motor RH (parking brake actuator assembly RH) input voltage 0.00 to 20.00 V - -
RH Actuator Motor +Terminal Voltage Parking brake motor RH (parking brake actuator assembly RH) positive (+) terminal side voltage 0.00 to 20.00 V - -
RH Actuator Motor -Terminal Voltage Parking brake motor RH (parking brake actuator assembly RH) negative (-) terminal side voltage 0.00 to 20.00 V - -
LH Actuator Motor Input Voltage Parking brake motor LH (parking brake actuator assembly LH) input voltage 0.00 to 20.00 V - -
LH Actuator Motor +Terminal Voltage Parking brake motor LH (parking brake actuator assembly LH) positive (+) terminal side voltage 0.00 to 20.00 V - -
LH Actuator Motor -Terminal Voltage Parking brake motor LH (parking brake actuator assembly LH) negative (-) terminal side voltage 0.00 to 20.00 V - -
EPB Switch Electric parking brake switch (electric parking brake switch assembly) input OFF, Lock, Release or Unknown OFF: Lock switch and release switch are off
Lock: Lock switch on Release: Release switch on
When not normal, electric parking brake switch (electric parking brake switch assembly) release side system may be malfunctioning
HINT:

EPB stands for electric parking brake.


Auto Mode Request Auto mode request status OFF or ON - -
Shift Position Position of shift lever P, N, R, D or Unknown P: Shift lever in P
N: Shift lever in N
R: Shift lever in R
D: Shift lever in D or M
When not normal, shift position signal system may be malfunctioning
IG Switch IG power source status OFF or ON OFF: IG power source voltage is not input to skid control ECU (brake actuator assembly)
ON: IG power source voltage is input to skid control ECU (brake actuator assembly)
-
Brake Hold Ready Brake hold control permission status OFF or ON - -
Brake Hold Control Mode Brake hold control mode OFF, ON, Release or EPB OFF: Brake hold control is not operating
ON: Brake hold control is operating
Release: Brake hold control is released
EPB: Parking brake is locked during brake hold control
HINT:

EPB stands for electric parking brake.


RH Actuator Current Status Parking brake actuator assembly RH monitoring current condition Inval or Valid Valid -
LH Actuator Current Status Parking brake actuator assembly LH monitoring current condition Inval or Valid Valid -
RH Actuator Nut Stroke Parking brake actuator assembly RH nut stroke value 0.000 to 8.160 mm (0 to 0.321 in.) - -
LH Actuator Nut Stroke Parking brake actuator assembly LH nut stroke value 0.000 to 8.160 mm (0 to 0.321 in.) - -
RH Actuator Motor Actual Current Parking brake motor RH (parking brake actuator assembly RH) current value -5.0362 to 50.5000 A - -
RH Actuator 0 load Current Parking brake motor RH (parking brake actuator assembly RH) current calibration value -5.0362 to 50.5000 A - -
LH Actuator Motor Actual Current Parking brake motor LH (parking brake actuator assembly LH) current value -5.0362 to 50.5000 A - -
LH Actuator 0 load Current Parking brake motor LH (parking brake actuator assembly LH) current value -5.0362 to 50.5000 A - -
Counter of IG ON After EPB Control Cancel Number of times the ignition switch was turned ON after EPB control was cancelled 0 to 255 Times - -
RH Actuator Status Parking brake actuator assembly RH condition Default, Lock, Lock Dynamic, Release, Lock Faulty, Unexpected, Lock Standby, Release Standby, Lock Dynamic Standby, Release Dynamic Standby, Lock Dynamic Faulty, Lock Standard Control, Lock Dynamic Control, Lock Control for Prevention Loosen by High Temperature, Lock Control for Prevention Slipping Down, Re-Lock Control by Switch, Recovery Lock Control, Lock Control After Dynamic PKB, Release Standard Control, Release Dynamic Control, Full Release Control - -
LH Actuator Status Parking brake actuator assembly LH condition Default, Lock, Lock Dynamic, Release, Lock Faulty, Unexpected, Lock Standby, Release Standby, Lock Dynamic Standby, Release Dynamic Standby, Lock Dynamic Faulty, Lock Standard Control, Lock Dynamic Control, Lock Control for Prevention Loosen by High Temperature, Lock Control for Prevention Slipping Down, Re-Lock Control by Switch, Recovery Lock Control, Lock Control After Dynamic PKB, Release Standard Control, Release Dynamic Control, Full Release Control - -
Detailed Freeze DTC Number of detailed freeze DTCs 0 to 65535 - -
RH Actuator Motor Gradient Current Parking brake motor RH (parking brake actuator assembly RH) current gradient -5.0362 to 50.5000 A - -
LH Actuator Motor Gradient Current Parking brake motor LH (parking brake actuator assembly LH) current gradient -5.0362 to 50.5000 A - -
RH Actuator Motor Relay1 Parking brake motor relay 1 RH condition OFF or ON - -
RH Actuator Motor Relay2 Parking brake motor relay 2 RH condition OFF or ON - -
RH Actuator Motor Relay3 Parking brake motor relay 3 RH condition OFF or ON - -
RH Actuator Motor Relay4 Parking brake motor relay 4 RH condition OFF or ON - -
LH Actuator Motor Relay1 Parking brake motor relay 1 LH condition OFF or ON - -
LH Actuator Motor Relay2 Parking brake motor relay 2 LH condition OFF or ON - -
LH Actuator Motor Relay3 Parking brake motor relay 3 LH condition OFF or ON - -
LH Actuator Motor Relay4 Parking brake motor relay 4 LH condition OFF or ON - -
RH Actuator Motor Current High Parking brake motor RH (parking brake actuator assembly RH) overcurrent status OFF or ON - -
RH Actuator Motor Driver Operation Status Parking brake motor RH (parking brake actuator assembly RH) driver status OK or NG - -
LH Actuator Motor Current High Parking brake motor LH (parking brake actuator assembly LH) overcurrent status OFF or ON - -
LH Actuator Motor Driver Operation Status Parking brake motor LH (parking brake actuator assembly LH) driver status OK or NG - -

*: Not equipped


a.

Using the GTS, the state of the vehicle (sensors) when the system is operating or when a DTC was stored can be checked.