The skid control ECU (brake actuator assembly) receives signals from the ECM and engine stop and start ECU (w/ Stop and Start System) via CAN communication.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | Note |
|---|---|---|---|---|---|
| U0100 | Lost Communication With ECM/PCM "A" | The +BS terminal voltage is between 9.6 and 16.5 V, the vehicle speed is 6 km/h (4 mph) or more, and signals cannot be sent to the ECM for 2 seconds or more. | ·
CAN communication system ·
Skid control ECU (brake actuator assembly) ·
ECM |
DTC stored | An electric parking brake system malfunction is displayed on the multi-information display. |
| U1103 | Lost Communication with Stop and Start Control Module | The +BS terminal voltage is between 9.6 and 16.5 V, the vehicle speed is 6 km/h (4 mph) or more, and signals cannot be sent to the engine stop and start ECU for 2 seconds or more. | ·
CAN communication system ·
Skid control ECU (brake actuator assembly) ·
Engine stop and start ECU |
DTC stored | An electric parking brake system malfunction is displayed on the multi-information display. |
Go to CAN communication system.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
| Proceed to |
|---|
| NEXT |
NEXT