84390B
1.INSPECT ELECTRIC PARKING BRAKE SWITCH ASSEMBLY
Check the resistance.
| *a | Component without harness connected
(Electric Parking Brake Switch Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 6 (SWI1) - 5 (SW01) | OFF (Release) | 10 kΩ or higher |
| ON (Lock) | Below 1 Ω | |
| Switch not operated | 10 kΩ or higher | |
| 6 (SWI1) - 4 (SWI2) | OFF (Release) | Below 1 Ω |
| ON (Lock) | Below 1 Ω | |
| Switch not operated | 10 kΩ or higher | |
| 6 (SWI1) - 3 (SW02) | OFF (Release) | Below 1 Ω |
| ON (Lock) | 10 kΩ or higher | |
| Switch not operated | Below 1 Ω | |
| 4 (SWI2) - 5 (SW01) | OFF (Release) | 10 kΩ or higher |
| ON (Lock) | Below 1 Ω | |
| Switch not operated | Below 1 Ω | |
| 4 (SWI2) - 3 (SW02) | OFF (Release) | Below 1 Ω |
| ON (Lock) | 10 kΩ or higher | |
| Switch not operated | 10 kΩ or higher |
If the result is not as specified, replace the electric parking brake switch assembly.
Check the Illuminates.
| *a | Component without harness connected
(Electric Parking Brake Switch Assembly) |
Apply battery voltage to the electric parking brake switch assembly and check that the switch illuminates.
| Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 7 (ILL+)
Battery negative (-) → Terminal 1 (ILL-) |
Illuminates |
If the result is not as specified, replace the electric parking brake switch assembly.