The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel pressure regulator assembly removal/installation are shown below.
*1: When performing learning using the GTS.
Never perform work on fuel system components near any possible ignition sources.
Vaporized fuel could ignite, resulting in a serious accident.
Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.
Sparks could cause vaporized fuel to ignite, resulting in a serious accident.
| *a | Tube |
Do not disconnect the tube shown in the illustration when disassembling the fuel suction tube with pump and gauge assembly. Doing so will cause reassembly of the fuel suction tube with pump and gauge assembly to be impossible as the tube is pressed into the No. 1 plate sub-assembly.
77020A
1.REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
23280J
2.REMOVE FUEL PRESSURE REGULATOR ASSEMBLY
Remove the No. 3 fuel suction support from the fuel suction tube with pump and gauge assembly.
| *a | Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, remove the fuel pressure regulator assembly from the fuel suction tube with pump and gauge assembly.
Pull out the fuel pressure regulator assembly carefully because the O-rings are firmly installed between the fuel pressure regulator assembly and the fuel suction tube with pump and gauge assembly.
| *1 | O-ring |
Remove the 2 O-rings from the fuel pressure regulator assembly.