Home › Engine / Hybrid System › 3ZR-FAE (FUEL) › FUEL SENDER GAUGE ASSEMBLY
RM32H0E _51 Engine / Hybrid System _060184 3ZR-FAE FUEL _0295037 FUEL SENDER GAUGE ASSEMBLY G

3ZR-FAE FUEL  FUEL SENDER GAUGE ASSEMBLY  INSPECTION  


PROCEDURE

Hide 83320 1.INSPECT FUEL SENDER GAUGE ASSEMBLY

CAUTION:

Perform the inspection in a well-ventilated area.

Do not perform the inspection near an open flame.


a.

Check that the float moves smoothly between F and E.


b.

Check the fuel sender gauge assembly voltage.

i.
A396714C01
0.25,0.167 0.563,0.365 0.313,0.198 10 false *a 1.667,2.5 1.979,2.698 0.313,0.198 10 false *b
*a Component without harness connected
(Fuel Sender Gauge Assembly)
*b Voltage Applied between Terminals


Apply 5 V between terminals 2 and 3.

NOTICE:
·

Be careful when connecting the leads, as the fuel sender gauge assembly may be damaged if the leads are connected to the wrong terminals.

·

Do not apply more than 6 V to terminals 2 or 3.



HINT:

If a stable power supply is not available, connect 4 nickel-metal hydride batteries (1.2 V each) or equivalent in series.



ii.
A396713C01
0.833,0.167 2.5,1.75 1.667,1.583 0.333,3.865 0.833,3.865 true 0.781,2.417 1.281,2.417 true 0.917,0.25 1.229,0.448 0.313,0.198 10 false *a 0.167,3.792 0.323,3.99 0.156,0.198 10 false E 0.604,2.344 0.76,2.542 0.156,0.198 10 false F
*a Component without harness connected
(Fuel Sender Gauge Assembly)


Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Float Level Specified Condition
1 - 2 F 4.255 to 4.605 V*
Between F and E 0.345 to 4.605 V* (Gradually changes)
E 0.345 to 0.695 V*


*: The output voltage changes depending on the voltage applied to the terminals.

Output voltage (F) = (0.851 x Voltage applied to terminals) to (0.921 x Voltage applied to terminals)

Output voltage (E) = (0.069 x Voltage applied to terminals) to (0.139 x Voltage applied to terminals)

If the result is not as specified, replace the fuel sender gauge assembly.