Home › Engine / Hybrid System › 3ZR-FAE (FUEL) › FUEL SENDER GAUGE ASSEMBLY › 2016.10–2019.09
RM32H0E _51 Engine / Hybrid System _060184 3ZR-FAE FUEL _0295037 FUEL SENDER GAUGE ASSEMBLY A

3ZR-FAE FUEL  FUEL SENDER GAUGE ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel sender gauge assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Simple intelligent parking assist system*1 (Click here)
Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Initialize back door lock Power door lock control system (Click here)

*1: When performing learning using the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/ Simple Intelligent Parking Assist System)>CALIBRATION

PROCEDURE

Hide 77020A 1.REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

Hide 83320 2.REMOVE FUEL SENDER GAUGE ASSEMBLY

a.
A395517

Disconnect the fuel sender gauge assembly connector.


b.

Disengage the 3 clamps to disconnect the wire harness.

NOTICE:

Do not damage the wire harness.



c.
A395516

Disengage the claw to remove the fuel sender gauge assembly from the fuel suction tube with pump and gauge assembly.

NOTICE:

Be careful not to bend the arm of the fuel sender gauge assembly.