Home › Engine / Hybrid System › 3ZR-FAE (EMISSION CONTROL) › PURGE VALVE
RM32H0E _51 Engine / Hybrid System _060194 3ZR-FAE EMISSION CONTROL _0295048 PURGE VALVE G

3ZR-FAE EMISSION CONTROL  PURGE VALVE  INSPECTION  


PROCEDURE

Hide 17650G 1.INSPECT PURGE VALVE (PURGE VSV)

a.
A194073E04
1.479,1.406 1.938,0.958 1.938,0.958 2.021,0.958 false 1.458,1.458 1.094,1.865 1.094,1.865 1,1.865 false 0.885,1.781 1,2.083 0.115,0.302 10 false 1 2.104,0.875 2.229,1.177 0.125,0.302 10 false 2

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 23 to 26 Ω


If the result is not as specified, replace the purge valve (purge VSV).


b.
A282778C01
0.542,0.438 0.448,0.438 0.448,0.438 0.448,1.104 false 0.938,1.813 1.042,1.813 1.042,1.813 1.104,1.323 false 0.74,1.74 1.052,1.896 0.313,0.156 10 *a 0.583,0.365 0.896,0.521 0.313,0.156 10 *b 1.583,1.708 1.896,1.865 0.313,0.156 10 *c
*a Port (E)
*b Port (F)
*c Air


Apply battery voltage between the terminals of the purge valve (purge VSV) and check that the following occurs when blowing air into the port (E).

OK:
Measurement Condition Specified Condition
Battery voltage applied between terminals 1 and 2 Air flows from port (F)
Battery voltage not applied between terminals 1 and 2 Air does not flow


If the result is not as specified, replace the purge valve (purge VSV).