Home › Engine / Hybrid System › 8NR-FTS (ENGINE CONTROL) › THROTTLE BODY
RM32H0E _51 Engine / Hybrid System _059353 8NR-FTS ENGINE CONTROL _0295065 THROTTLE BODY G

8NR-FTS ENGINE CONTROL  THROTTLE BODY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 22030 1.INSPECT THROTTLE BODY WITH MOTOR ASSEMBLY

a.

Check the idle speed.

i.

Start the engine and check that the MIL is not illuminated. After the engine is warmed up, check that the idle speed is within the specified range with the A/C switch off (w/ Air conditioning system).

Standard Idle Speed:
for Manual Transaxle:

600 to 700 rpm

for CVT:

680 to 780 rpm


NOTICE:
·

Be sure to perform this step with all accessories off.

·

Make sure that the shift lever is in P or N.




ii.

Perform a road test and confirm that there are no abnormalities.



b.

Inspect the throttle position sensor.

i.

Connect the GTS to the DLC3.


ii.

Start the engine.


iii.

Turn the GTS on.


iv.

Enter the following menus: Powertrain / Engine / Data List / Throttle Sensor Position.

Powertrain > Engine > Data List
Tester Display
Throttle Sensor Position
50003 372 308

v.

Depress the accelerator pedal. When the throttle valve is fully open, check that the Throttle Sensor Position value is as specified.

Standard Throttle Valve Opening Percentage:
GTS Display Specified Condition
Throttle Sensor Position 60% or higher


NOTICE:
·

When checking the throttle valve opening percentage, the shift lever should be in N.

·

Fully depress the accelerator pedal.



If the percentage is less than 60%, replace the throttle body with motor assembly.