Home › Engine / Hybrid System › 8NR-FTS (ENGINE CONTROL) › ACCELERATOR PEDAL
RM32H0E _51 Engine / Hybrid System _059353 8NR-FTS ENGINE CONTROL _0295067 ACCELERATOR PEDAL A

8NR-FTS ENGINE CONTROL  ACCELERATOR PEDAL  INSTALLATION  


PROCEDURE

Hide 78110K 1.INSTALL ACCELERATOR PEDAL SENSOR ASSEMBLY

NOTICE:
·

Avoid physical shock to the accelerator pedal sensor assembly.

·

Do not disassemble the accelerator pedal sensor assembly.

·

The accelerator pedal sensor assembly does not require lubrication.

·

Do not apply oil or other lubricants to the accelerator pedal sensor assembly. If applied, the accelerator pedal sensor assembly must be replaced.



a.

Install the accelerator pedal sensor assembly with the 3 nuts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)

NOTICE:

If the accelerator pedal sensor assembly has been struck or dropped, replace it.



b.

Connect the accelerator pedal sensor assembly connector.