Home › Engine / Hybrid System › 8NR-FTS (ENGINE CONTROL) › MASS AIR FLOW METER
RM32H0E _51 Engine / Hybrid System _059353 8NR-FTS ENGINE CONTROL _0295068 MASS AIR FLOW METER A

8NR-FTS ENGINE CONTROL  MASS AIR FLOW METER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the mass air flow meter removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Replacement of mass air flow meter Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 22204 1.REMOVE MASS AIR FLOW METER

a.
A392703

Disengage the clamp and disconnect the mass air flow meter connector.


b.

Remove the 2 screws and mass air flow meter from the air cleaner cap sub-assembly.

NOTICE:

If the mass air flow meter has been struck or dropped, replace it.