Home › Engine / Hybrid System › 8NR-FTS (ENGINE CONTROL) › IGNITION COIL AND SPARK PLUG
RM32H0E _51 Engine / Hybrid System _059353 8NR-FTS ENGINE CONTROL _0295071 IGNITION COIL AND SPARK PLUG A

8NR-FTS ENGINE CONTROL  IGNITION COIL AND SPARK PLUG  INSTALLATION  


PROCEDURE

Hide 19100P 1.INSTALL SPARK PLUG

Hide 19500D 2.INSTALL NO. 1 IGNITION COIL

HINT:

Perform "Inspection After Repair" after replacing a No. 1 ignition coil.

Click hereEngine / Hybrid System>8NR-FTS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION


a.

Install the 4 No. 1 ignition coils to the cylinder head cover sub-assembly with the 4 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:

If a No. 1 ignition coil has been struck or dropped, replace it.


HINT:

Install the same parts to their original positions.



b.

Connect the 3 No. 1 ignition coil connectors.


c.

Install the engine wire to the cylinder head cover sub-assembly with the nut.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


d.

Engage the 2 clamps.


e.

Connect the camshaft position sensor connector.


f.

Connect the No. 1 ignition coil connector.


g.

Connect the fuel pump assembly connector.


h.

Connect the sensor wire connector.


Hide 3.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing a No. 1 ignition coil or spark plug.

Click hereEngine / Hybrid System>8NR-FTS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION