Home › Engine / Hybrid System › 8NR-FTS (ENGINE CONTROL) › KNOCK SENSOR › 2016.10–2019.09
RM32H0E _51 Engine / Hybrid System _059353 8NR-FTS ENGINE CONTROL _0295074 KNOCK SENSOR A

8NR-FTS ENGINE CONTROL  KNOCK SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the knock sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link

*1: When performing learning using the GTS

Click here(Click here)

*2: w/ Stop and start system

Disconnect cable from negative battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Pre-collision syatem
Initialize back door lock Power door lock control system (Click here)
Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2 Stop and start system (Click here)

PROCEDURE

Hide 89615 2.REMOVE KNOCK SENSOR

a.
A392724

Remove the bolt and separate the No. 4 engine wire.


b.
A392725

Disconnect the knock sensor connector.


c.

Remove the bolt and knock sensor from the cylinder block sub-assembly.

NOTICE:

If the knock sensor has been struck or dropped, replace it.