Home › Engine / Hybrid System › 8NR-FTS (COOLING) › THERMOSTAT(for Cylinder Block)
RM32H0E _51 Engine / Hybrid System _060195 8NR-FTS COOLING _0295084 THERMOSTAT(for Cylinder Block) G

8NR-FTS COOLING  THERMOSTAT(for Cylinder Block)  INSPECTION  


PROCEDURE

Hide 16331A 1.INSPECT THERMOSTAT (for Cylinder Block)

A326229

HINT:

The valve opening temperature is inscribed on the thermostat (for Cylinder Block).


a.

Immerse the thermostat (for Cylinder Block) in water, and then gradually heat the water.


b.

Check that the valve of the thermostat (for Cylinder Block) opens at the specified temperature.

Standard Valve Opening Temperature:

76 to 80°C (169 to 176°F)


If the result is not as specified, replace the thermostat (for Cylinder Block).


c.
A328758C01
2.635,1.563 2.948,1.719 0.313,0.156 10 false *a
*a Valve Lift


Check the valve lift.

Standard Valve Lift:

8.0 mm (0.315 in.) or more at 91°C (196°F)


If the result is not as specified, replace the thermostat (for Cylinder Block).


d.

Check that the valve is fully closed when the thermostat (for Cylinder Block) is at low temperature (below 73°C (163°F)).

If it is not fully closed, replace the thermostat (for Cylinder Block).