Home › Engine / Hybrid System › 3ZR-FAE (COOLING) › RADIATOR
RM32H0E _51 Engine / Hybrid System _060196 3ZR-FAE COOLING _0295095 RADIATOR G

3ZR-FAE COOLING  RADIATOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 16475A 1.INSPECT RESERVE TANK CAP

a.
A287226C04
2.063,1.458 2.458,1.458 false 0.813,1.698 1.219,1.698 false 0.646,1.615 0.958,1.771 0.313,0.156 10 *a 2.5,1.375 2.813,1.531 0.313,0.156 10 *b
*a O-ring
*b Rubber Packing


Measure the valve opening pressure.

i.

If there are water stains or foreign matter on the O-ring, clean it with water and finger scouring.


ii.

Check that the O-ring is not deformed, cracked or swollen.


iii.

Apply engine coolant to the O-ring and rubber packing before using a radiator cap tester.


iv.
A249860C06
2.104,0.156 1.938,0.156 1.938,0.156 1.625,0.469 false 0.979,0.26 0.813,0.26 0.813,0.26 0.5,0.573 false 0.635,1.073 0.854,1.313 0.219,0.24 10 *b 2.167,0.073 2.438,0.354 0.271,0.281 10 *a 1.042,0.177 1.281,0.417 0.24,0.24 10 *1
*1 Reserve Tank Cap
*a Radiator Cap Tester
*b 30° or more


When using the radiator cap tester, tilt it upwards 30° or more.


v.

Pump the radiator cap tester several times, and check the maximum pressure.

Pump Speed:

1 pump per second


HINT:

Even if the reserve tank cap cannot maintain the maximum pressure, it is not a defect.


Result:
Item Specified Condition
Standard pressure
(for brand-new reserve tank cap)
93 to 123 kPa (0.9 to 1.3 kgf/cm2, 13.5 to 18.0 psi)
Minimum pressure
(for used reserve tank cap)
79 kPa (0.8 kgf/cm2, 11.4 psi)


If the maximum pressure is less than the minimum pressure, replace the reserve tank cap.



Hide 2. INSPECT FINS FOR BLOCKAGE

A347897

a.

If the fins are clogged, wash them with water or a steam cleaner and dry them with compressed air.

NOTICE:
·

To avoid damaging the fins, keep the tip of the nozzle at right angles to the core surface.

·

If the nozzle of the steam cleaner is too close to the core, there is a possibility of damaging the fins. Always maintain the following distances from the core when using a steam cleaner.

Standard Steam Cleaner Nozzle Distance
Steam Pressure Specified Condition
2942 to 4903 kPa (30.0 to 50.0 kgf/cm2, 427 to 711 psi) 300 mm (11.8 in.)
4903 to 7845 kPa (50.0 to 80.0 kgf/cm2, 711 to 1138 psi) 500 mm (19.7 in.)

·

If the fins are bent, straighten them with a screwdriver or pliers.

·

Do not expose electronic components to water.