Home › Engine / Hybrid System › 3ZR-FAE (COOLING) › COOLING FAN ECU
RM32H0E _51 Engine / Hybrid System _060196 3ZR-FAE COOLING _0295097 COOLING FAN ECU G

3ZR-FAE COOLING  COOLING FAN ECU  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK COOLING FAN SYSTEM

a.

Check and ensure the following conditions:

i.

The ignition switch is off.


ii.

The engine coolant temperature is less than 86°C (187°F).


iii.

The battery voltage is between 11 to 14 V.


iv.

The A/C switch is off.



b.

Connect the pickup of a clamp-on ammeter around either of the 2 wires for the cooling fan motor.


c.

Turn the ignition switch to ON and wait for approximately 10 seconds. Check that the cooling fans are not operating.


d.

Start the engine. Check that the cooling fans are not operating with the engine idling.

HINT:
·

Make sure that the engine coolant temperature is less than 91°C (196°F).

·

Turn the A/C switch off.




e.

Check that the cooling fans operate when the A/C switch is turned on.


f.

Measure the current while the cooling fan motors are turning.

Standard Current:
Item Condition Specified Condition
Cooling fan motor Battery voltage applied at 20°C (68°F) 7.4 to 10.9 A


HINT:

The engine coolant temperature should be less than 91°C (196°F).



g.

Check that the cooling fans operate when the engine coolant temperature sensor connector is disconnected.


h.

Measure the current while the cooling fan motors are turning.

Standard Current:
Item Condition Specified Condition
Cooling fan motor Battery voltage applied at 20°C (68°F) 7.4 to 10.9 A



i.
A320309C07
0.094,0.073 0.458,0.344 0.365,0.271 10 false *a 0.146,2.115 0.458,2.271 0.313,0.156 10 false *b 0.427,1.135 0.74,1.292 0.313,0.156 10 false *c 0.417,1.688 0.729,1.844 0.313,0.156 10 false *d 0.396,2.542 0.708,2.698 0.313,0.156 10 false *e 0.427,3.094 0.74,3.25 0.313,0.156 10 false *f 1.229,3.656 1.448,3.896 0.219,0.24 10 false 91 1.635,3.656 1.854,3.896 0.219,0.24 10 false 93 2.24,3.656 2.458,3.896 0.219,0.24 10 false 96 2.667,3.656 2.885,3.896 0.219,0.24 10 false 98 1.177,3.865 1.635,4.063 0.458,0.198 10 false 196 1.594,3.865 2.052,4.063 0.458,0.198 10 false 199 2.208,3.865 2.667,4.063 0.458,0.198 10 false 205 2.646,3.865 3.104,4.063 0.458,0.198 10 false 208 2.99,3.646 3.313,3.927 0.323,0.281 10 false (°C) 3,3.865 3.333,4.125 0.333,0.26 10 false (°F)
*a Operating Diagram
*b Fan Speed
*c MAX HI
*d HI
*e LO
*f OFF


After the engine is warmed up, check that the cooling fans operate as shown in the illustration.

HINT:
·

The engine coolant temperature at which the fans start operating is approximately 93°C (199°F).

·

This system can also be checked using the GTS.

Enter the following menus: Powertrain / Engine / Data List / Coolant Temperature



Powertrain > Engine > Data List
Tester Display
Coolant Temperature
50003 372 205