Home › Engine / Hybrid System › 8NR-FTS (STARTING) › ENGINE SWITCH (for RHD)
RM32H0E _51 Engine / Hybrid System _060199 8NR-FTS STARTING _0295156 ENGINE SWITCH(for RHD) G

8NR-FTS STARTING  ENGINE SWITCH(for RHD)  INSPECTION  


PROCEDURE

Hide 1.INSPECT ENGINE SWITCH

a.

Check the resistance

i.
B268088C19
0.781,0.792 1.229,1.156 true 2.177,1.188 2.573,0.833 true 2.188,1.406 2.542,1.708 true 2.646,0.76 3.104,0.958 0.458,0.198 10 false SS2 2.573,1.667 3.031,1.865 0.458,0.198 10 false AGND 0.49,0.729 0.948,0.927 0.458,0.198 10 false SS1 0.104,0.073 0.563,0.271 0.458,0.198 12 false *a
*a Component without harness connected
(Engine Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
5 (SS1) - 6 (AGND) Not pushed 10 kΩ or higher
1 (SS2) - 6 (AGND)
5 (SS1) - 6 (AGND) Pushed Below 1 Ω
1 (SS2) - 6 (AGND)


If the result is not as specified, replace the engine switch.



b.

Check the LED illumination.

i.
B268088C20
1.042,1.865 1.458,1.448 true 2.198,1.427 2.542,1.76 true 0.76,1.781 1.375,1.979 0.615,0.198 10 true SWIL 2.583,1.719 3.198,1.917 0.615,0.198 10 false AGND 0.115,0.115 0.49,0.354 0.375,0.24 12 false *a
*a Component without harness connected
(Engine Switch)


Apply battery voltage between the terminals of the engine switch and check the illumination condition of the engine switch indicator light.

OK:
Condition Specified Condition
Battery positive (+) → Terminal 9 (SWIL)
Battery negative (-) → Terminal 6 (AGND)
Illuminates


If the result is not as specified, replace the engine switch.