1.INSPECT ENGINE SWITCH
Check the resistance
| *a | Component without harness connected
(Engine Switch) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 5 (SS1) - 6 (AGND) | Not pushed | 10 kΩ or higher |
| 1 (SS2) - 6 (AGND) | ||
| 5 (SS1) - 6 (AGND) | Pushed | Below 1 Ω |
| 1 (SS2) - 6 (AGND) |
If the result is not as specified, replace the engine switch.
Check the LED illumination.
| *a | Component without harness connected
(Engine Switch) |
Apply battery voltage between the terminals of the engine switch and check the illumination condition of the engine switch indicator light.
| Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 9 (SWIL)
Battery negative (-) → Terminal 6 (AGND) |
Illuminates |
If the result is not as specified, replace the engine switch.