Home › General › SPECIFICATIONS › 3ZR-FAE STARTING
RM32H0E _V1 General _059376 SPECIFICATIONS _0295173 3ZR-FAE STARTING F

SPECIFICATIONS  3ZR-FAE STARTING  SERVICE DATA  


Starter Assembly
Tester Connection Condition Specified Condition
Battery positive (+) terminal - Terminal 30 - Terminal 50 11.5 V Below 90 A

Magnet Starter Switch Assembly
Tester Connection Condition Specified Condition
Terminal 50 - Terminal C Always Below 1 Ω
Terminal 50 -Magnet switch body Below 2 Ω

Starter Armature Assembly
Tester Connection Condition Specified Condition
Segment - Segment Always Below 1 Ω
Segment - Starter armature core 10 kΩ or higher

Commutator for runout Standard Runout 0.02 mm (0.000787 in.)
Maximum Runout 0.04 mm (0.00157 in.)

Commutator diameter Standard Diameter 25.9 mm (1.0197 in.)
Minimum Diameter 24.9 mm (0.9803 in.)

Undercut depth Standard Undercut Depth 0.9 mm (0.0354 in.)
Minimum Undercut Depth 0.4 mm (0.0157 in.)

Starter Brush Holder Assembly
Brush length Standard Length 10.2 mm (0.402 in.)
Minimum Length 7.0 mm (0.276 in.)

Tester Connection Condition Specified Condition
A - B
A - C
B - D
C - D
Always 10 kΩ or higher
A - D
B - C
Below 1 Ω

Engine Switch
Tester Connection Condition Specified Condition
5 (SS1) - 6 (AGND) Not pushed 10 kΩ or higher
1 (SS2) - 6 (AGND)
5 (SS1) - 6 (AGND) Pushed Below 1 Ω
1 (SS2) - 6 (AGND)
Battery positive (+) →Terminal 9 (SWIL) Battery negative (-) →Terminal 6 (AGND) Illuminates

Ignition or Starter Switch Assembly
Tester Connection Condition Specified Condition
Between all terminals LOCK 10 kΩ or higher
5 (AM1) - 7 (ACC) ACC Below 1 Ω
5 (AM1) - 7 (ACC) - 8 (IG1) ON Below 1 Ω
3 (IG2) - 4 (AM2)
5 (AM1) - 6 (ST1) - 8 (IG1) START Below 1 Ω
2 (ST2) - 3 (IG2) - 4 (AM2)

Starter Relay Assembly
Tester Connection Condition Specified Condition
3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
Battery voltage applied to terminals 1 and 2 Below 1 Ω