Home › Power Source / Network › 8NR-FTS (BATTERY / CHARGING) › BATTERY CURRENT SENSOR › 2016.10–2019.09
RM32H0E _57 Power Source / Network _060209 8NR-FTS BATTERY / CHARGING _0295246 BATTERY CURRENT SENSOR A

8NR-FTS BATTERY / CHARGING  BATTERY CURRENT SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the battery state sensor assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link

*1: When performing learning using the GTS

Click here(Click here)

*2: w/ Stop and start system

Disconnect cable from negative battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Pre-collision syatem
Initialize back door lock Power door lock control system (Click here)
Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2 Stop and start system (Click here)

PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 28850C 2.REMOVE BATTERY STATE SENSOR ASSEMBLY

a.
A392494

Remove the nut to disconnect the engine wire from the battery state sensor assembly.


b.
A392495

Loosen the nut and disconnect the battery state sensor assembly from the battery.


c.
A392496

Disconnect the battery state sensor assembly connector.


d.

Disengage the clamp and disconnect the engine wire from the battery state sensor assembly.


e.
A392497

Disengage the 2 claws and remove the battery state sensor assembly from the battery current sensor holder.