87710G
1.INSPECT QUICK HEATER ASSEMBLY
| *a | Component without harness connected
(Quick Heater Assembly) |
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Always | Below 6 Ω |
| 3 - 2 | Always | Below 6 Ω |
| 3 - 4 | Always | Below 6 Ω |
| 5 - 4 | Always | Below 6 Ω |
If the result is not as specified, replace the quick heater assembly.