88474
1.INSTALL COOLER DRYER (for VALEO Made)
| *a | Modulator |
Using needle-nose pliers install a new cooler dryer to the modulator.
Apply sufficient compressor oil to the O-ring.
VC100YF or equivalent
Keep the O-rings and O-ring fitting surfaces free from dirt or foreign matter.
| *a | Modulator |
Using a T55 "TORX" socket wrench, install the cap to the modulator.
88474
2.INSTALL COOLER DRYER (for DENSO Made)
| *a | Modulator |
Using pliers, install a new cooler dryer to the modulator.
Sufficiently apply compressor oil to the 3 O-rings and fitting surfaces of a new cap.
ND-OIL 8 or equivalent
Keep the O-rings and O-ring fitting surfaces free from dirt or foreign matter.
| *a | Modulator |
Using a 14 mm straight hexagon, install the cap to the modulator.