55607
1.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
87138C
2.REMOVE BLOWER RESISTOR (for Single Type)
|
Remove in this Direction |
Disengage the guides and separate the blower resistor as shown in the illustration.
Disconnect the connector to remove the blower resistor.
87138C
3.REMOVE BLOWER RESISTOR (for Dual Type)
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Disengage the guides and separate the blower resistor as shown in the illustration.
Disconnect the connector to remove the blower resistor.