Use the same procedure for RHD and LHD vehicles.
The following procedure is for the LHD vehicles.
88051A
1.INSTALL ION GENERATOR SUB-ASSEMBLY
Install the ion generator sub-assembly and air duct sub-assembly to the No. 1 ion generator bracket with the 2 screws.
Install the ion generator sub-assembly with No. 1 ion generator bracket with the 2 scews.
Disconnect the connector.
55084E
2.INSTALL NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY
55401E
3.INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY