Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › REAR DRIVE SHAFT ASSEMBLY (for TMMT Made)
RM32H0E _52 Drivetrain _060137 DRIVE SHAFT / PROPELLER SHAFT _0295579 REAR DRIVE SHAFT ASSEMBLY(for TMMT Made) A

DRIVE SHAFT / PROPELLER SHAFT  REAR DRIVE SHAFT ASSEMBLY(for TMMT Made)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 42360M 1.INSTALL REAR DRIVE SHAFT INBOARD JOINT SHAFT SNAP RING LH

a.

Install a new rear drive shaft inboard joint shaft snap ring LH.


Hide 42340B 2.INSTALL REAR DRIVE SHAFT ASSEMBLY LH

a.

Coat the splines of the rear drive inboard joint assembly LH with Toyota Genuine Differential Gear Oil LT.


b.
C331020

Align the inboard joint splines, and using a brass bar and a hammer, install the rear drive shaft assembly.

NOTICE:
·

Face the end gap of the rear drive shaft inboard joint shaft snap ring LH downward.

·

Do not damage the rear drive shaft oil seal.

·

Do not damage the rear drive shaft inboard joint boot LH.

·

Make sure to center the rear drive shaft assembly during installation to prevent damage to the rear drive shaft inboard joint shaft snap ring LH.



HINT:

Confirm whether the drive shaft is securely driven in by checking the reaction force and sound.



Hide 3.INSTALL REAR AXLE CARRIER ASSEMBLY

Hide 4.ADD DIFFERENTIAL OIL

Hide 5.INSPECT FOR DIFFERENTIAL OIL LEAK