Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › REAR DRIVE SHAFT ASSEMBLY (for TMC Made)
RM32H0E _52 Drivetrain _060137 DRIVE SHAFT / PROPELLER SHAFT _0295582 REAR DRIVE SHAFT ASSEMBLY(for TMC Made) A

DRIVE SHAFT / PROPELLER SHAFT  REAR DRIVE SHAFT ASSEMBLY(for TMC Made)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the rear drive shaft assembly LH removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Rear wheel alignment adjustment
1.

Clear zero point calibration data.

2.

Perform yaw rate and acceleration sensor zero point calibration.


·

DTCs are stored

·

ABS warning light illuminates

·

Slip indicator light illuminates

·

VSC disabled or malfunctions


(Click here)
Removal/installation of rear height control sensor sub-assembly LH*1 Initialize headlight ECU sub-assembly LH Automatic headlight beam level control system (Click here)
Suspension, tires, etc.
(The vehicle height changes because of suspension or tire replacement)*1

*1: w/ Height Control Sensor


HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 42312B 1.DRAIN DIFFERENTIAL OIL

Hide 2.REMOVE REAR AXLE CARRIER ASSEMBLY

Hide 42340B 3.REMOVE REAR DRIVE SHAFT ASSEMBLY LH

a.
C368134N01
1.01,1.438 0.479,1.677 0.479,1.677 0.677,1.104 true 0.177,1.719 0.5,1.917 0.323,0.198 10 true SST

Using SST, remove the rear drive shaft assembly LH from the rear differential carrier assembly.

SST
09520-01010  
09520-24010  (09520-32040)

NOTICE:
·

Do not damage the rear drive shaft oil seal.

·

Do not damage the inboard joint boot LH.

·

Do not drop the rear drive shaft assembly LH.

·

When removing the rear drive shaft assembly LH, keep it level.




Hide 42360M 4.REMOVE REAR DRIVE SHAFT INBOARD JOINT SHAFT SNAP RING LH

C129495

a.

Using a screwdriver, remove the rear drive shaft inboard joint shaft snap ring LH.