Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › REAR DRIVE SHAFT ASSEMBLY (for TMC Made)
RM32H0E _52 Drivetrain _060137 DRIVE SHAFT / PROPELLER SHAFT _0295582 REAR DRIVE SHAFT ASSEMBLY(for TMC Made) G

DRIVE SHAFT / PROPELLER SHAFT  REAR DRIVE SHAFT ASSEMBLY(for TMC Made)  INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
·

When using a vise, place aluminum plates between the part and vise.

·

When using a vise, do not overtighten it.



PROCEDURE

Hide 1.INSPECT REAR DRIVE SHAFT ASSEMBLY

a.
C116430

Check that there is no excessive play in the radial direction of the outboard joint.


b.

Check that the inboard joint slides smoothly in the thrust direction.


c.

Check that there is no severe play in the radial direction of the inboard joint.


d.

Check the 2 joint boots for damage.


e.
C127699N04
1.438,1.521 1.656,1.74 0.219,0.219 10 (A)

Check whether the drive shaft dimensions (A) are within the following specifications.

Dimension (A):
LH Side RH Side
742.2 mm (2.44 ft.) 728.7 mm (2.39 ft.)


NOTICE:

Keep the drive shaft assembly level during inspection.


If the boots are stretched or contracted, correct them.