Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR SUPPORT
RM32H0E _59 Vehicle Exterior _060017 DOOR / HATCH _0295672 BACK DOOR SUPPORT A

DOOR / HATCH  BACK DOOR SUPPORT  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 68948 1.INSTALL BACK DOOR DAMPER STAY LOWER BRACKET

a.

Clean the threaded portion on the vehicle body with non-residue solvent.


b.

Apply adhesive to the threads of the 2 bolts.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



c.

Install the 2 bolts and back door damper stay lower bracket.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


Hide 68946 2.INSTALL BACK DOOR DAMPER STAY UPPER BRACKET

a.

Clean the threaded portion on the vehicle body with non-residue solvent.


b.

Apply adhesive to the threads of the 2 bolts.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



c.

Install the back door damper stay upper bracket with the 2 bolts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


Hide 68960B 3.INSTALL BACK DOOR STAY ASSEMBLY

CAUTION:
·
B450745

Do not perform work if the back door is not securely supported.

·

The back door could fall, resulting in injury.



NOTICE:
·

Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while servicing.

·

Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.

·

Do not apply any horizontal load to the door stay in order to prevent the piston rod from deforming.



a.

When reusing the back door stay assembly:

i.

Install the 2 stop rings to the back door stay assembly.



b.
B450749

Install the back door stay assembly.

NOTICE:
·

Install the back door stay assembly while supporting the back door by hand.

·

Check that the back door stay assembly is engaged in the ball joint and that the back door support assembly cannot be pulled out.