Home › Vehicle Exterior › DOOR / HATCH › FUEL LID OPENER MOTOR ASSEMBLY
RM32H0E _59 Vehicle Exterior _060017 DOOR / HATCH _0295673 FUEL LID OPENER MOTOR ASSEMBLY G

DOOR / HATCH  FUEL LID OPENER MOTOR ASSEMBLY  INSPECTION  


PROCEDURE

Hide 77030A 1.INSPECT FUEL LID LOCK WITH MOTOR ASSEMBLY

a.

Check the operation of the fuel lid lock with motor assembly (motor operation).

i.
B450753C01
0.646,1.396 0.792,1.188 false 1.958,2.833 2.271,3.24 true 1.677,2.844 1.448,3.229 true 1,2.24 1.313,2.438 0.313,0.198 10 false *a 0.49,1.396 0.802,1.594 0.313,0.198 10 false *e 2.781,1.448 3.094,1.646 0.313,0.198 10 false *d 3,1.448 3.219,1.656 0.219,0.208 10 false *b 3.208,1.448 3.427,1.656 0.219,0.208 10 false *c 2.344,3.188 2.5,3.385 0.156,0.198 10 false B 1.302,3.188 1.458,3.385 0.156,0.198 10 false E
*a Component without harness connected
(Fuel Lid Lock with Motor Assembly)
*b Shaft Stroke
*c Shaft not pushed
*d Shaft Pushed
*e Lever


Apply battery voltage to the fuel lid lock with motor assembly connector, and measure the shaft stroke.

OK:
Battery Connection Specified Condition
Battery positive (+) → Terminal 1 (B)
Battery negative (-) → Terminal 2 (E)
16.05 mm (0.632 in.)


If the result is not as specified, replace the fuel lid lock with motor assembly.



b.

Measure the shaft stroke.

OK:
Area Condition Specified Condition
Shaft stroke Lever pulled 16.05 mm
(0.632 in.)


If the result is not as specified, replace the fuel lid lock with motor assembly.