Home › Drivetrain › EC6A (MANUAL TRANSMISSION / TRANSAXLE) › MANUAL TRANSAXLE UNIT
RM32H0E _52 Drivetrain _059609 EC6A MANUAL TRANSMISSION / TRANSAXLE _0295676 MANUAL TRANSAXLE UNIT G

EC6A MANUAL TRANSMISSION / TRANSAXLE  MANUAL TRANSAXLE UNIT  INSPECTION  


PROCEDURE

Hide 33402 1.INSPECT REVERSE IDLER GEAR SUB-ASSEMBLY

a.
C195814

Using a caliper gauge, inspect the reverse idler gear sub-assembly.

Standard Inside Diameter:

25.056 to 25.074 mm (0.9864 to 0.9871 in.)


Maximum Inside Diameter:

25.074 mm (0.9871 in.)


If the inside diameter exceeds the maximum, replace the reverse idler gear sub-assembly.


b.

Using a micrometer, inspect the reverse idler gear shaft.

Standard Outer Diameter:

24.984 to 25.000 mm (0.9836 to 0.9842 in.)


Minimum Outer Diameter:

24.984 mm (0.9836 in.)


If the outer diameter is less than the minimum, replace the reverse idler gear shaft.